Introducing the next evolution in trimming technology!
The WFT 2 TRIMMER from LITTLE CROW GUNWORKS is designed for precision and versatility in cartridge trimming. This innovative tool features two significant improvements over its predecessor:
- Ability to trim up to 45 caliber
- Interchangeable trim chambers for enhanced functionality
With a half inch shaft, the WFT 2 requires a half inch chuck for operation. One of the most requested features by our customers was the ability to interchange trim chambers. Unlike the original WFT, which used a press fit for trim chambers, the WFT 2 employs a slight slip fit in bearing with a groove cut for an O-ring, ensuring a secure press fit.
Changing trim chambers is straightforward; simply remove the cutter and push out the trim chamber using the provided knock-out dowel. To install a new trim chamber, place it on a flat surface and steadily push the housing onto it.
Setting the cutter depth is easily accomplished by placing a “master case” in the trim chamber, sliding the cutter up to the case mouth, and tightening the set screws. The trimming process remains as precise and clean as with our original trimmer.
The trim chamber selection for the WFT 2 is based on specific cartridges, yet it trims by case family. Just order the largest chamber in the family that you intend to trim. Please note that this unit and its inserts do not chamfer or deburr the case mouth of the cartridge case while trimming.
If you can't find the cartridge you need, please contact our Special Order Department at 800-741-0015.