Discover the next generation of precision trimming with the WFT 2 Trimmer!
The WFT 2 Trimmer from LITTLE CROW GUNWORKS is designed for enthusiasts who demand the best in trimming technology. This innovative tool boasts two major improvements over its predecessor:
- Capability to trim up to .45 caliber
- Interchangeable trim chambers
With a half inch shaft, the WFT 2 requires a half inch chuck to operate effectively. One of the most requested features by customers was the ability to interchange trim chambers easily. Unlike the original WFT, which utilized a press fit for the trim chambers, the WFT 2 incorporates a slight slip fit design with a groove cut for an O-ring, ensuring a secure press fit.
Changing trim chambers is a breeze; simply remove the cutter and use the included knock-out dowel to push out the trim chamber. To install a new trim chamber, set it on a flat surface and steadily push the housing onto it. Adjusting the cutter depth is straightforward: place a “master case” in the trim chamber, slide the cutter up to the case mouth, and tighten the set screws for precision.
Trimming with the WFT 2 is just as precise and clean as with the original model. The selection of trim chambers is based on specific cartridges, but you can still trim by case family—just order the largest chamber in the family you intend to trim.
Please note that this unit and its inserts do not chamfer or deburr the case mouth of the cartridge case during trimming. If you cannot find the cartridge you need, feel free to contact our Special Order Department at 800-741-0015.