Introducing the WFT 2 Trimmer – the ultimate tool for precision trimming!
The WFT 2 is the next generation of WFT trimmers, designed to enhance your reloading experience with two significant improvements:
- The ability to trim up to .45 caliber
- Interchangeable trim chambers
Featuring a half-inch shaft, the WFT 2 requires a half-inch chuck to operate effectively. One of the most requested features from our customers was the ability to interchange trim chambers. Unlike the original WFT, where the trim chambers were press-fitted, the WFT 2 incorporates a slight slip fit in bearing with a groove cut for an O-ring, ensuring a secure press fit.
Changing out trim chambers is a breeze; simply remove the cutter and use the provided knock-out dowel to push out the trim chamber. To install a new trim chamber, place it on a flat surface and steadily push the housing onto it.
Setting the cutter depth is straightforward—just place a master case in the trim chamber, slide the cutter up to the case mouth, and tighten down the set screws. Trimming remains as precise and clean as with our original trimmer.
The trim chamber selection for the WFT 2 is based on specific cartridges, yet it trims by case family. Just order the largest chamber in the family that you intend to trim. Please note that this unit and its inserts do not chamfer or deburr the case mouth of the cartridge case during trimming.
If you can't find the cartridge you need, please contact our Special Order Department at 800-741-0015.