Introducing the WFT 2 Trimmer – the ultimate tool for precision trimming!
The WFT 2 is the next generation of WFT trimmers from LITTLE CROW GUNWORKS. Designed with user feedback in mind, this innovative trimmer offers two main improvements:
- The ability to trim up to .45 caliber.
- Interchangeable trim chambers for added versatility.
Featuring a half inch shaft, the WFT 2 requires a half inch chuck to drive it. One of the most requested features by customers was the ability to interchange trim chambers. Unlike the original WFT, which used press fitting for the trim chambers, the WFT 2 employs a slight slip fit in bearing with a groove cut for an O-ring, creating a secure press fit.
Changing out trim chambers is straightforward; simply remove the cutter and use the provided knock-out dowel to push out the trim chamber. To install a new trim chamber, set it on a flat surface and steadily push the housing onto the trim chamber.
Adjusting the cutter depth is easy. Place a master case in the trim chamber, slide the cutter up to the case mouth, and tighten down the set screws. Trimming remains as precise and clean as with our original trimmer.
The trim chamber selection on the WFT 2 is based on specific cartridges, but it still trims by case family. Just order the largest chamber in the family that you intend to trim. Please note, this unit and its inserts do not chamfer or deburr the case mouth of the cartridge case as it is trimmed.
If you can't find the cartridge you need, please contact our Special Order Department at 800-741-0015.