Introducing the WFT 2 Trimmer – the next evolution in precision trimming!
The WFT 2 is the latest advancement in WFT trimmers, designed to enhance your reloading experience with two significant improvements:
- The capability to trim up to .45 caliber.
- The ability to interchange trim chambers easily.
Featuring a half inch shaft, the WFT 2 requires a half inch chuck for operation. One of the most requested features from our customers was the ability to swap out trim chambers. Unlike the original WFT, which used press-fitting, the trim chambers on the WFT 2 have a slight slip fit in bearing with a groove cut for an O-ring that creates a secure press fit.
Changing trim chambers is straightforward: simply remove the cutter and push out the trim chamber using the provided knock-out dowel. To install a new trim chamber, set it on a flat surface and steadily push the housing onto it.
Adjusting the cutter depth is a breeze; just place a “master case” in the trim chamber, slide the cutter up to the case mouth, and tighten down the set screws. Trimming remains as precise and clean as with our original trimmer.
The trim chamber selection on the WFT 2 is by specific cartridge, but it still trims by case family—simply order the largest chamber in the family you wish to trim. Please note that this unit and its inserts do not chamfer or deburr the case mouth of the cartridge case during trimming.
If you can't find the cartridge you need, please contact our Special Order Department at 800-741-0015.