Introducing the WFT 2 Trimmer from Little Crow Gunworks – the ultimate tool for precision trimming!
The WFT 2 Trimmer is the next generation of WFT trimmers, designed to enhance your reloading experience with remarkable improvements.
Key Features:
- Trimming Capacity: Capable of trimming up to .45 caliber.
- Interchangeable Trim Chambers: Easily switch trim chambers without the hassle of press fitting.
- Half Inch Shaft: Requires a half inch chuck for operation.
The WFT 2 features a half inch shaft and requires a compatible chuck to drive it. One of the most requested features by customers was the ability to interchange trim chambers. Unlike the original WFT, which used press fitting for the trim chambers, the WFT 2 employs a slight slip fit in bearing, complemented by a groove cut for an O-ring to create a secure press fit.
Changing out trim chambers is straightforward: simply remove the cutter and use the provided knock-out dowel to push out the trim chamber. To install a new trim chamber, set it on a flat surface and steadily push the housing onto it. Adjusting the cutter depth is easy – place a “master case” in the trim chamber, slide the cutter up to the case mouth, and tighten the set screws.
Trimming with the WFT 2 remains as precise and clean as with the original model. The trim chamber selection is based on specific cartridges, but it still trims by case family – just order the largest chamber in the family you intend to trim. Please note that this unit and its inserts do not chamfer or deburr the case mouth of the cartridge as it is trimmed.
If you can't find the cartridge you need, please contact our Special Order Department at 800-741-0015.