Introducing the WFT 2 Trimmer – the ultimate tool for precision trimming!
The WFT 2 is the next generation of WFT trimmers, designed for both enthusiasts and professionals alike. This innovative tool boasts two main improvements:
- The ability to trim up to 45 caliber.
- Interchangeable trim chambers.
Featuring a half inch shaft, the WFT 2 requires a half inch chuck for operation. One of the most requested features by our customers is the ability to interchange trim chambers. Unlike the original WFT, which used a press fit for the trim chambers, the WFT 2 employs a slight slip fit in bearing with a groove cut for an O-ring that creates a secure press fit.
Changing trim chambers is simple: just remove the cutter and push out the trim chamber using the knock-out dowel provided. To install a new trim chamber, place it on a flat surface and steadily push the housing onto it. Adjusting the cutter depth is easy—simply place a “master case” in the trim chamber, slide the cutter up to the case mouth, and tighten down the set screws.
Trimming with the WFT 2 is just as precise and clean as with our original trimmer. The trim chamber selection is based on specific cartridges, but it still trims by case family—just order the largest chamber in the family that you intend to trim.
Please note that this unit and its inserts do not chamfer or deburr the case mouth of the cartridge case during trimming. If you can't find the cartridge you need, feel free to contact our Special Order Department at 800-741-0015.