Introducing the WFT 2 Trimmer – the ultimate tool for precision trimming!
The WFT 2 Trimmer from LITTLE CROW GUNWORKS is the next generation of WFT trimmers, designed to enhance your reloading experience with two significant improvements:
- The ability to trim up to .45 caliber.
- Interchangeable trim chambers for added versatility.
Featuring a half-inch shaft, the WFT 2 requires a half-inch chuck for operation. One of the most requested features by our customers is the ability to interchange trim chambers. Unlike the original WFT, which used a press fit for the trim chambers, the WFT 2 employs a slight slip fit in bearing with a groove cut for an O-ring, ensuring a secure press fit.
Changing out trim chambers is a breeze; simply remove the cutter and use the provided knock-out dowel to push out the trim chamber. To install a new trim chamber, place it on a flat surface and steadily push the housing onto the trim chamber.
Setting the cutter depth is straightforward – just insert a “master case” into the trim chamber, slide the cutter up to the case mouth, and tighten the set screws. Trimming with the WFT 2 is just as precise and clean as with our original trimmer.
The trim chamber selection for the WFT 2 is based on specific cartridges, while still allowing trimming by case family. Simply order the largest chamber in the family you intend to trim.
Please note that this unit and its inserts do not chamfer or deburr the case mouth of the cartridge case while trimming.
If you can't find the cartridge you need, don't hesitate to contact our Special Order Department at 800-741-0015.