Tough, steel clamp captures the bolt head, and the large-handled turnscrew depresses the ejector so the ejector pin can be safely removed or installed. Set includes turnscrews to fit both Standard and Small bolt faces; also included are separate bolt head retainers. One will fit bolt bodies up to .720" diameter (standard and small bolt face) and the other will fit AR-15/M16 bolts only. Complete AR-15/M16 Bolt Ejector Tool also available separately. Tools work on bolts with plunger-style ejectors and forward-positioned locking lugs only.
SPECS: Steel, blued. Plastic handle. Includes instructions.
More...
Customer ratings for BROWNELLS AR-15/M16 BOLT EJECTOR TOOL
Number of ratings: 6
From brownells.com: 6
Average rating: 2.3
not recommended(19/01/2010)
This tool is not recommended for ar bolts. It moves around too much when trying to drive roll pin out and does not secure the bolt .
Great Tool(09/04/2011)
Works exactly as advertised
Economical tool for the job(30/04/2012)
Read the instructions... My only gripe is one thing,"You have to clamp it real good while installing the roll pin.
Needs offset(20/04/2014)
Worked ok, but with AR bolt ejector, would be better if screw in device was offset to engage ejector and not in center.
fell apart(29/09/2014)
The cylinder section in the handle fell out. Seemed like it would work great but I can't tighten the driver part of the tool to depress the ejector.
A disappointment. Failed(01/03/2015)
After 38 years of trying to remove the AR ejector without assistance I finally broke down and purchased this tool. It did not hold up. The jaws bent. The handle separated. It was marginally helpful at best. I upgraded to the more expensive but much better Brownell's ejector tool that can be placed on the bench. The more expensive tool is far superior and makes ejector removal a snap.
Tough, steel clamp captures the bolt head, and the large-handled turnscrew depresses the ejector so the ejector pin can be safely removed or installed. Set includes turnscrews to fit both Standard and Small bolt faces; also included are separate bolt head retainers. One will fit bolt bodies up to .720" diameter (standard and small bolt face) and the other will fit AR-15/M16 bolts only. Complete AR-15/M16 Bolt Ejector Tool also available separately. Tools work on bolts with plunger-style ejectors and forward-positioned locking lugs only.
SPECS: Steel, blued. Plastic handle. Includes instructions.
More...
Customer ratings for BROWNELLS AR-15/M16 BOLT EJECTOR TOOL
Number of ratings: 6
From brownells.com: 6
Average rating: 2.3
not recommended(19/01/2010)
This tool is not recommended for ar bolts. It moves around too much when trying to drive roll pin out and does not secure the bolt .
Great Tool(09/04/2011)
Works exactly as advertised
Economical tool for the job(30/04/2012)
Read the instructions... My only gripe is one thing,"You have to clamp it real good while installing the roll pin.
Needs offset(20/04/2014)
Worked ok, but with AR bolt ejector, would be better if screw in device was offset to engage ejector and not in center.
fell apart(29/09/2014)
The cylinder section in the handle fell out. Seemed like it would work great but I can't tighten the driver part of the tool to depress the ejector.
A disappointment. Failed(01/03/2015)
After 38 years of trying to remove the AR ejector without assistance I finally broke down and purchased this tool. It did not hold up. The jaws bent. The handle separated. It was marginally helpful at best. I upgraded to the more expensive but much better Brownell's ejector tool that can be placed on the bench. The more expensive tool is far superior and makes ejector removal a snap.