Attributes
- Gauge:
20 Gauge
- Model Number: -
- Weapon type:
Universal Shotguns
- Delivery weight: 0.113kg
- Shipping height: 13mm
- Shipping width: 51mm
- Shipping length: 876mm
- UPC: 050806018976
Product no.: 080606120
Mfr. No.: 00052
050806018976 Flex Hone~ 20 Gauge Med. BoreDelivery time approx. 7-14 days.
The SHOTGUN BARREL POLISHING FLEX HONE® by BROWNELLS is designed to provide a superior polish for shotgun bores. This innovative tool is essential for any gunsmith or firearm enthusiast aiming for top-tier performance.
The Flex Hone is available for various gauges:
With a length of 33" (83.8cm), it comes in two grit options: Med.-Coarse (red tip) and Fine (light blue tip). Additionally, the Flex Hone for Chambers is available in a 12" (6.5cm) fine grit (light blue only).
The medium grit is 180 grit silicon carbide, while the fine grit is 800 grit aluminum oxide. This set is perfect for maintaining the integrity and performance of your shotgun.
Elevate your shotgun's performance with the BROWNELLS Flex Hone, ensuring a truly outstanding finish polish on your shotgun bores!
20 Gauge
Universal Shotguns
Easy and effective. Highly recommended 12/01/2016
I am upping my game this turkey season with a new Leupold shotgun scope on top of my Beretta A400 Extreme. New Rhino turkey choke, Nitro shells should be lethal. Buddy told me I should polish the bore and chamber to tighten up groups and add some lethality. He described an arduous hours long process with many steps. I did some research and found the Flex Hone system. Sounded too good to be true. Bought it because I trust Brownell's. Received it today. Kit contains both 400 and 800 grit bore rods, one 800 grit chamber rod and a quart of Flex Hone's cutting oil. I swear it took no more than 20 minutes to polish both chamber and bore to a mirror shine. If you want an ultra shiny bore, this is the product for you. Ten passes in and out is all it took. Don't overdo it as you might take off too much steel. Watch Flex Hone's video for instructions. I didn't wash it out with soapy water as they suggest, just dry patches until they were clean followed with a slightly oily one.
too short 27/05/2011
I figured the 12 inch would be long enough to handle this old 410 I was restoring for my grandson- but it wasn't- there remained a 3 inch section in the middle that I could not hone- It did a beautiful job on what I could reach but the center section well it didn't look too good. I had a bit extender but it was too large in diameter to get into the barrell. I ended up with a wirebrush with some steel wool on it and did a pretty good job- I would like to see an extension that would fit inside the barrell.
We encountered an error while loading this content. Please refresh the page to continue. If the issue persists, contact our customer support.